全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 常见问题

常见问题

驾驶自动上料搅拌车要避免的三个问题

作者:http://www.zkzsljbc.com 时间:2023-02-27

自动上料搅拌车是一种自动上料的搅拌车类型,可以有效节省人力的使用,成为各个建筑厂家所喜爱的一种搅拌车类型,但是它的工作并不仅仅局限于混凝土的搅拌工作,还包括混凝土的运输工作,由于车辆的结构比较特殊,在驾驶的过程中是很容易发生一些危险事故的,所以下面我们来看一下驾驶自动上料搅拌车要避免的问题。
Automatic loading mixer is a type of automatic loading mixer, which can effectively save the use of manpower and become a type of mixer preferred by various construction manufacturers. However, its work is not limited to the mixing of concrete, but also includes the transportation of concrete. Due to the special structure of the vehicle, it is easy to cause some dangerous accidents during driving, So let's take a look at the problems to avoid when driving the automatic feeding mixer.
一、过度热车
1、 Overheated car
不管是冬季还是其它季节,有很多车主都习惯采取原地怠速热车的方式,热车一段时间再行驶,觉得自动上料搅拌车,这时性能佳。但事实上,原地怠速热车不仅效果有限,还浪费汽油和时间。当引擎在没有负荷的状态下,温度的爬升是相当缓慢的。
No matter in winter or in other seasons, many car owners are used to idling the hot car in place. When the hot car is driven for a period of time, they feel that the performance of the automatic feeding mixer is good. But in fact, the effect of idling in situ is not only limited, but also a waste of gasoline and time. When the engine is under no load, the temperature climb is quite slow.
也就是说,引擎在怠速状态下需要很长的时间才能达到正常的工作温度。正确的做法应当是自动上料搅拌车,原地热车30秒左右后,立即上路行驶。但由于此时引擎及驱动系统都尚未达到正常的工作温度,仍应将转速控制在约2000转/分钟之内,待水温达到正常后方可高转速运行。
In other words, it takes a long time for the engine to reach the normal operating temperature at idle speed. The correct way to do this is to use the automatic loading mixer truck. After the truck is hot in place for about 30 seconds, it will start driving immediately. However, since the engine and drive system have not reached the normal operating temperature at this time, the speed should still be controlled within about 2000 rpm, and the high speed operation can be carried out after the water temperature reaches normal.
自动上料搅拌车
二、熄火后仍使用电器设备
2、 Use electrical equipment after flameout
一旦自动上料搅拌车,熄火,蓄电池就处于只放电不充电的工作状态。所以如果在长时间熄火后仍然一直在使用车内大功率用电器,比如开着车辆大灯、停车在路边长时间听音乐等等,这样可能很快导致蓄电池彻底放电、自动上料搅拌车,无法启动的严重后果。
Once the automatic loading mixer is turned off, the battery will be in the working state of only discharging and not charging. Therefore, if you still use high-power electrical appliances in the car after a long time of flameout, such as driving the vehicle headlights, parking at the roadside for a long time to listen to music, etc., this may soon lead to complete discharge of the battery, automatic loading mixer, and serious consequences of not being able to start.
三、油箱见底后才加油
3、 Fill the fuel tank only after it reaches the bottom
有人比较懒,有人是很少去注意油箱刻度,直到油箱警示灯亮起后还会再行驶一段距离再去加油。可是有时燃油警示灯亮起后再去找加油站时,有可能出现附近没有加油站的情况,弄得手忙脚乱。而且经常出现这样的情况的话,自动上料搅拌车,的油泵寿命可能会大大降低。
Some people are lazy. Some people pay little attention to the fuel tank scale. They will drive for some distance before refueling until the fuel tank warning light is on. But sometimes when you go to the gas station after the fuel warning light is on, there may be no gas station nearby, which makes you in a hurry. In addition, if this happens frequently, the life of the oil pump of the automatic feeding mixer may be greatly reduced.
以上就是有关驾驶自动上料搅拌车要避免的三个问题解答了,希望给你帮助,当然有购买设备的需求就来我们网站http://www.zkzsljbc.com联系吧!
These are the answers to three questions to avoid when driving an automatic loading mixer. I hope to help you. Of course, if you need to buy equipment, please come to our website http://www.zkzsljbc.com Contact me!
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码