对自上料搅拌车的使用，很多人都不去充分的了解相关事项以及有关的问题，所以就会导致不少设备使用过程中出现大的问题。那么今天，对自上料搅拌车的使用这里有建议要给出了。

For the use of self loading mixer, many people do not fully understand the relevant matters and problems, which will lead to major problems in the use of many equipment. So today, there are some suggestions for the use of self loading mixer.

如果自上料搅拌车的液压泵需要更换，一般不建议自己更换。直接到售后点找人员更换，使用的油品需要符合要求，否则会对设备造成很大的损坏，缩短使用寿命。合理标注的液压油。

If the hydraulic pump from the loading mixer needs to be replaced, it is generally not recommended to replace it yourself. Go directly to the after-sales point to find professionals to replace. The oil used needs to meet the requirements, otherwise it will cause great damage to the equipment and shorten the service life. Reasonably labeled hydraulic oil.

如果油封使用时间长了，油封就会磨损，只需要更换新的油封即可。长期不换油，滤芯质量下降，油液太脏，油封磨损加快，尽快更换液压油和滤芯。

If the oil seal is used for a long time, the oil seal will be worn. Just replace it with a new one. If the oil is not changed for a long time, the quality of the filter element decreases, the oil is too dirty, and the wear of the oil seal is accelerated. Replace the hydraulic oil and filter element as soon as possible.

传动轴失去平衡，剧烈振动，造成主轴摆动油封磨损，需及时固定更换轴。液压油会变质乳化，降低润滑性能，加速油封磨损。应尽快更换液压油和滤芯。在严重的情况下，需要对系统进行清洁。

The transmission shaft is out of balance and vibrates violently, causing the main shaft to swing and the oil seal is worn. The shaft needs to be fixed and replaced in time. The hydraulic oil will deteriorate and emulsify, reduce the lubrication performance and accelerate the wear of oil seal. Replace the hydraulic oil and filter element as soon as possible. In severe cases, the system needs to be cleaned.

泵支架松动，泵打开，泵固定螺栓松动，造成整个液压泵振动，油封磨损，经常检查并排除全自动上料搅拌叉车发生故障的可能，以防万一并避免失败。

The pump support is loose, the pump is opened, and the pump fixing bolts are loose, resulting in the vibration of the whole hydraulic pump and the wear of the oil seal. Regularly check and eliminate the possibility of failure of the full-automatic feeding and mixing forklift, just in case and avoid failure.

自动加油/混动一体车系统回油不畅，回油管和散热器堵塞，造成电机壳内压力升高，油封漏油。必须堵塞物并稳定回油回路。散热器上的障碍物并冷却系统，以防止泵电机磨损。在严重的情况下，必须停止和停止发动机，并用水冲洗泵的电机和散热器外壳进行冷却。

The oil return of automatic refueling / hybrid integrated vehicle system is not smooth, and the oil return pipe and radiator are blocked, resulting in the increase of pressure in the motor housing and oil leakage of oil seal. The blockage must be removed and the return circuit stabilized. Remove obstructions from the radiator and cool the system to prevent pump motor wear. In severe cases, the engine must be stopped and stopped, and the motor and radiator housing of the pump must be washed with water for cooling.

冬季运行时，由于预热不足，油温过低，油封、油封达不到理想的工作温度。对策：启动时停止油箱，怠速运转10～20分钟，待油温恢复正常后更换油箱。

During winter operation, due to insufficient preheating and low oil temperature, the oil seal and oil seal can not reach the ideal working temperature. Countermeasures: stop the oil tank when starting, idle for 10 ~ 20 minutes, and replace the oil tank after the oil temperature returns to normal.

如果散热器不散热，油温会变得过高，粘度和润滑性会降低，油封会过热，油封无法工作。自上料搅拌车液压泵轴端的油封非常脆弱。严格遵守相关规定可以有效防止多次漏油。如果您遇到漏油，您需要冷静下来并确定问题的具体原因。

If the radiator does not dissipate heat, the oil temperature will become too high, the viscosity and lubricity will be reduced, the oil seal will overheat and the oil seal will not work. The oil seal at the shaft end of the hydraulic pump of the loading mixer is very fragile. Strict compliance with relevant regulations can effectively prevent multiple oil spills. If you experience an oil leak, you need to calm down and determine the specific cause of the problem.

对自上料搅拌车的使用这里有建议要给出的相关内容就到这里了，如果您对此有什么疑惑的话，可以先过来我们网站www.zkzsljbc.com看看，咨询下。

Here are some suggestions on the use of self loading mixer. If you have any doubts about this, you can come to our website www.zkzsljbc See and consult. Com.