全自动搅拌车行驶过程中，突然出现状况导致搅拌车走不了，这时又不清楚到底是哪里出现了问题，当务之急是混凝土必须及时排卸出来，避免它凝结在罐体内。

During the driving process of the fully automatic mixing truck, a sudden condition occurred which caused the mixing truck to stop moving. At this time, it was not clear where the problem was. The top priority was that the concrete must be discharged in time to avoid its condensation in the tank.

如果此时搅拌车的马达或加速机能正常使用，那么要赶快找一辆和自己车辆的马达、车泵相同的搅拌车来，连接紧急驱动软管，依靠另一辆搅拌车的动力将混凝土排卸出来。具体操作步骤：

If the motor or acceleration function of the mixing truck is in normal use at this time, you should quickly find a mixing truck with the same motor and pump as your own vehicle, connect the emergency drive hose, and discharge the concrete with the power of another mixing truck. Specific operation steps:

1.准备好紧急驱动软管，卸下接管和接头盖。

1. Prepare the emergency drive hose and remove the connecting pipe and connector cover.

2.将故障车的发动机熄火，将左右两个紧固螺母旋松，再将旋钮朝右旋转，直到不能再旋为止，将高压软管从马达接头处卸下，将紧急驱动软管接到马达接头上，把紧急驱动软管的接管与故障车卸下的高压软管相接，以防漏油。

2. Turn off the engine of the faulty vehicle, unscrew the left and right fastening nuts, and then turn the knob to the right until it can no longer be turned. Remove the high-pressure hose from the motor connector, connect the emergency drive hose to the motor connector, and connect the connecting pipe of the emergency drive hose to the high-pressure hose removed from the faulty vehicle to prevent oil leakage.

3.救援车的操作：将操作手柄于空挡位置，将发动机熄火，把高压软管从高压油管出卸下，将紧急驱动软管接到高压软管上，用紧急驱动软管上的接头盖将驱动车的高压软管盖起，以防漏油。

3. Operation of the rescue vehicle: set the operating handle to the neutral position, turn off the engine, remove the high-pressure hose from the high-pressure oil pipe, connect the emergency drive hose to the high-pressure hose, and cover the high-pressure hose of the drive vehicle with the connector cap on the emergency drive hose to prevent oil leakage.

4.启动救援车的发动机。5.将救援车的操作手柄拨“出料”位置，让故障车内的混凝土排出6.紧急驱动完毕后，将两车恢复原状，查找故障车出故障原因，修理车辆。

4. Start the engine of the rescue vehicle. 5. Turn the operating handle of the rescue vehicle to the "discharge" position to let the concrete in the fault vehicle be discharged. 6. After the emergency drive is completed, restore the two vehicles to their original state, find out the cause of the fault vehicle and repair the vehicle.

如果搅拌车出故障行走不了，而此时搅拌车的马达和加速机也出现故障，那也要想其它办法将混凝土及时排出。更多相关内容就来我们网站http://www.zkzsljbc.com进行咨询！

If the mixing truck fails to move, and the motor and accelerator of the mixing truck also fails, other ways should be taken to discharge the concrete in time. Come to our website for more relevant content http://www.zkzsljbc.com Consult!