搅拌车是常见的运输混凝土，黏土的一种运输工具，在运输途中应该确保无误，整个过程中混凝土以及泥土都会得到搅拌，这样直到到达了目的地，混凝土以及黏土的质量还是能够保持良好。
全自动搅拌车的液压转动系统使用要求如下：
The mixer is a common means of transporting concrete and clay. It should be ensured that there is no mistake during the transportation. The concrete and soil will be mixed during the whole process, so that the quality of concrete and clay can be kept good until the destination is reached. The operating requirements of the hydraulic rotation system of the fully automatic mixer truck are as follows:
1、新车开始使用前，首先检查和清除液压系统各处的灰尘和杂物，并检查各处连接是否正确和有无其它问题。
1. Before the new car is used, first check and remove the dust and sundries in the hydraulic system, and check whether the connections are correct and whether there are other problems.
2、油箱中装液压油到油标刻度线以上，泵壳和马达壳内也要充油。
2. The oil tank shall be filled with hydraulic oil above the oil scale mark, and the pump housing and motor housing shall also be filled with oil.
3、启动发动机，操纵伺服手柄使小型搅拌车拌筒在低速下正转，观察液压系统是否正常工作。
3. Start the engine, operate the servo handle to make the mixing drum of the small mixing truck rotate forward at low speed, and observe whether the hydraulic system works normally.
4、注意散热器上的风扇在50℃-70℃范围内应是运转状态，风扇发生故障不运转时，应及时修理。
4. Note that the fan on the radiator should be in operation within the range of 50 ℃ - 70 ℃. If the fan fails to operate, it should be repaired in time.
5、补油泵溢流阀、低压溢流阀、高压溢流阀压力出厂时已调定，不得随意改动。
5. The pressure of the oil make-up pump overflow valve, low pressure overflow valve and high pressure overflow valve has been set at the factory and shall not be changed at will.
6、小型搅拌车油路中各部件及管路不得有漏油现象，如发生渗漏，应及时修理。
6. All parts and pipelines in the oil circuit of small mixer truck shall be free of oil leakage. In case of leakage, repair it in time.
The operating requirements of the hydraulic rotation system of the fully automatic mixer truck are explained here in six aspects, which can be used as a reference. More precautions can be found on our website http://www.zkzsljbc.com Consult!
点击拨打服务热线：400-879-1999