Oil inspection of mixer truck

只要隔几天把油表尺拔出，擦干净、再放进去、再拔出来，看看机油的液面高低是否在上限与下限之间。如果在日常的检查中发现机油内有杂质或汽油味，以及排烟呈现淡蓝色，就表示引擎出了问题，机件可能异常磨损，需要赶快检修哦!

Just pull out the oil gauge every few days, wipe it clean, put it in and pull it out again to see if the oil level is between the upper and lower limits. If impurities or gasoline smell are found in the engine oil during daily inspection, and the smoke exhaust is light blue, it indicates that there is something wrong with the engine. The parts may be abnormally worn and need to be repaired as soon as possible!

搅拌车汽油检查

Gasoline inspection of mixer truck

要勤于查看油表是否到底。千万不要让油表到底了再去加油，新车多都采电动汽油泵棒以及油量电子感应器，要注意让它浸泡在汽油里散热，此外油量太低，也可能影响排气系统的氧传感器器，这些零件都不便宜，所以勿超过底线才去加油。

Be diligent in checking whether the oil gauge is in the end. Never let the fuel gauge go to the end before refueling. Most new cars use electric gasoline pump rods and electronic fuel volume sensors. Pay attention to let it soak in gasoline to dissipate heat. In addition, too low fuel volume may also affect the oxygen sensor of the exhaust system. These parts are not cheap, so don't refuel beyond the bottom line.

搅拌车变速箱油检查

Inspection for gearbox oil of mixer truck

检查变速箱油，为了测量准确，应该将车排入空档P，以怠速运转，并将车停在平坦的地方，且油液必运转至80℃~93℃的工作温度。油液过多或过少，都可能损害变速箱，油液过多可能会造成机件运转阻力过大，或者使得变速箱油起泡变质而致机件不正常磨损。

Check the transmission oil. In order to measure accurately, drain the vehicle into neutral P, run at idle speed, park the vehicle in a flat place, and the oil must run to the working temperature of 80 ℃ ~ 93 ℃. Too much or too little oil may damage the transmission. Too much oil may cause excessive running resistance of parts, or make the transmission oil bubble and deteriorate, resulting in abnormal wear of parts.

搅拌车刹车油如何检查

How to check the brake oil of mixer truck

只要打开引擎盖，看看刹车油壶的液面高低，要不低于下限。在未检查刹车油液面高度时，不可添加刹车油，以免添加过量，而使刹车油喷洒至高温引擎，导致机件腐蚀甚至起火燃烧。如果刹车油中起了气泡，或油变脏了，就表示刹车油已经变质了，请尽快更换，以免刹车油沸点降低产生气泡，造成刹车效果变差，容易发生危险。

Just open the hood and check the level of the brake oil pot. It should not be lower than the lower limit. When the brake oil level is not checked, do not add brake oil to avoid excessive addition, which will spray the brake oil to the high-temperature engine, resulting in corrosion and even fire. If there are bubbles in the brake oil or the oil becomes dirty, it means that the brake oil has deteriorated. Please replace it as soon as possible to avoid bubbles caused by the reduction of the boiling point of the brake oil, resulting in poor braking effect and danger.

以上就是今天带给大家的知识自动上料搅拌车专注行业多年，为用户不断的提供有价值的内容，更多内容请继续关注我们：http://www.zkzsljbc.com

The above is the knowledge brought to you today. The automatic feeding mixer has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.zkzsljbc.com