全国咨询热线

400-879-1999

点击拨打服务热线:400-879-1999
你所在位置: 首页 >> 新闻中心 > 常见问题

常见问题

多功能搅拌车的“挡油”问题介绍

作者:http://www.zkzsljbc.com 时间:2022-01-06

如果长时间使用,油封会磨损。解决方案:只需更换新的油封即可。
If used for a long time, the oil seal will wear. Solution: just replace the new oil seal.
如果长时间不更换机油,则滤芯的质量会下降,机油会变得太脏,并且油封的磨损会更快。解决方案:尽快更换液压油和滤芯。
If the oil is not changed for a long time, the quality of the filter element will decline, the oil will become too dirty, and the wear of the oil seal will be faster. Solution: replace the hydraulic oil and filter element as soon as possible.
驱动轴失衡并剧烈振动,导致主轴摆动油封磨损。解决方案:及时固定并更换轴。
The drive shaft is unbalanced and vibrates violently, resulting in the wear of the main shaft swing oil seal. Solution: fix and replace the shaft in time.
液压油会变质和乳化,降低润滑性能并加速油封的磨损。解决方案:尽快更换液压油和滤芯。在严重的情况下,需要清洁系统。
The hydraulic oil will deteriorate and emulsify, reduce the lubrication performance and accelerate the wear of the oil seal. Solution: replace the hydraulic oil and filter element as soon as possible. In severe cases, the system needs to be cleaned.
泵支架松动,泵打开,泵固定螺栓松动,导致整个液压泵振动并磨损油封。解决方案:始终检查并消除全自动供料和混合叉车发生故障的可能性,以防止并避免发生故障。
The pump support is loose, the pump is opened, and the pump fixing bolts are loose, resulting in vibration of the whole hydraulic pump and wear of the oil seal. Solution: always check and eliminate the possibility of failure of fully automatic feeding and mixing forklift to prevent and avoid failure.
自动加油/混合动力一体式车辆系统的回油不畅,回油管和散热器堵塞,导致电动机壳体内的压力升高,并且油封泄漏。解决方案:清除堵塞物并稳定回油回路。
The oil return of the automatic refueling / hybrid integrated vehicle system is not smooth, and the oil return pipe and radiator are blocked, resulting in increased pressure in the motor housing and oil seal leakage. Solution: remove the blockage and stabilize the oil return circuit.
自上料搅拌车
如果散热器不散热,油的温度将变得太高,粘度和润滑性将降低,油封将过热并且密封将无法工作。
If the radiator does not dissipate heat, the oil temperature will become too high, the viscosity and lubricity will be reduced, the oil seal will overheat and the seal will not work.
解决方案:清除散热器上的障碍物并冷却系统,以防止泵马达磨损。在严重的情况下,有必要停止和停止发动机,并用水冲洗泵的电动机和散热器壳体以达到冷却效果。
Solution: remove obstacles from the radiator and cool the system to prevent wear of the pump motor. In severe cases, it is necessary to stop and stop the engine and flush the pump motor and radiator housing with water to achieve cooling effect.
在冬季运行期间,由于预热不足,油温过低,油封和油封无法达到理想的工作温度。对策:启动时停止油箱,以怠速运转10至20分钟,并在机油温度恢复正常时更换油箱。
During winter operation, due to insufficient preheating and low oil temperature, the oil seal and oil seal cannot reach the ideal working temperature. Countermeasures: stop the oil tank when starting, run at idle speed for 10 to 20 minutes, and replace the oil tank when the oil temperature returns to normal.
以上就是全自动搅拌车给大家的精彩内容,更多的精彩内容请点击:http://www.zkzsljbc.com我们后续会有更多的精彩内容等您查看.
The above are the highlights of the automatic mixer truck. For more highlights, please click: http://www.zkzsljbc.com We will have more wonderful content for you to check later
新闻中心
联系我们
  • 公司:莱州聚峰机械有限公司
  • 热线:400-879-1999
  • 地址:山东省莱州市206国道与308省道交叉口东南50米

截屏,微信识别二维码