If the brake cylinder of the automatic mixer leaks brake fluid or the cylinder pipeline is broken, use iron sheet and copper sheet as a small cushion at the cylinder pipeline joint to block the pipeline, and then tighten the screw, or clamp the fracture flat and curl to block the leakage, so that the wheel can not be used for braking. However, doing so may cause unilateral braking. Pay attention to safety when driving.

自动搅拌车制动总泵缺制动液，可用酒精或白酒代替，特殊情况下可用清水代替。自动搅拌车制动皮碗发涨，将发涨的皮碗放在热水中浸泡10分钟-20分钟，将皮碗上的含油成分去掉，这样就可以使皮碗恢复原来的尺寸。

The brake fluid of the automatic mixer is replaced by alcohol or baijiu. When the brake cup of the automatic mixer truck rises, soak the rising cup in hot water for 10-20 minutes to remove the oil content on the cup, so that the cup can return to its original size.

自动搅拌车离合器摩擦片烧蚀打滑，对烧蚀不太严重的摩擦片，可翻面使用。如烧蚀严重，可用棉布或帆布数层（其厚度应与原摩擦片一致），用钢丝或铁丝穿过钢片上的孔，使其固定。驾驶自动搅拌车时应做到起步平稳，换挡动作迅速。

The friction plate of clutch of automatic mixer truck is ablated and skidded. The friction plate with less serious ablation can be turned over for use. If the ablation is serious, several layers of cotton cloth or canvas can be used (its thickness should be consistent with the original friction plate), and steel wire or iron wire can be used to pass through the hole on the steel plate to fix it. When driving the automatic mixer truck, it shall start smoothly and shift quickly.

横拉杆球节断损，在保险杠或其它不影响自动搅拌车行驶的地方，卸下一只与球节总长度相似的螺钉，取代断损的球节，装上转向节臂与螺母后，将螺钉露出部分用锤子铆好。三轴自动搅拌车差速器齿轮损坏，如中、后桥差速器损坏任何一只，都可将该桥传动轴和半轴拆下，自动搅拌车继续行驶。若前差速器损坏，可将自动搅拌车轮毂接合盘拆下后继续行驶。

The tie rod ball joint is broken. In the bumper or other places that do not affect the driving of the automatic mixer, remove a screw similar to the total length of the ball joint to replace the broken ball joint. After installing the steering knuckle arm and nut, rivet the exposed part of the screw with a hammer. If the differential gear of the three axle automatic mixer is damaged, if either the middle and rear axle differential is damaged, the transmission shaft and half shaft of the axle can be removed, and the automatic mixer continues to drive. If the front differential is damaged, remove the hub adapter of the automatic mixing wheel and continue driving.

.自动搅拌车应停入在平地上，并且将铲斗平放地面。当发动机熄火后，需要反复多次扳动工作装置操纵手柄，确保各液压缸都处于无压休息的状态。当装载机只能停在坡道上的时侯，要将轮胎垫牢。不准停在有明火或高温地区，以防轮胎受热爆炸，引起事故,先取走电锁的钥匙，然后再关闭电源总开关，关闭门窗

. the automatic mixer truck shall stop on a flat ground and place the bucket flat on the ground. After the engine is shut down, the operating handle of the working device needs to be pulled repeatedly to ensure that all hydraulic cylinders are in a state of no pressure rest. When the loader can only stop on the ramp, the tires shall be padded firmly. It is not allowed to stop in areas with open fire or high temperature to prevent accidents caused by tire heating and explosion. First remove the key of the electric lock, then turn off the main power switch and close the doors and windows

以上就是今天小编带给大家的精彩内容，全自动搅拌车将不断深化自身的实力，不断的提高质量，做好价格公正，欢迎大家在网站上点击购买：http://www.zkzsljbc.com

The above is the wonderful content brought to you by Xiaobian today. The automatic mixer will continue to deepen its strength, continuously improve its quality and do a good job in price justice. You are welcome to click to buy on the website: http://www.zkzsljbc.com