1、 Ensure that there is enough water and water reducing agent in the tank of concrete mixer truck

一般搅拌机所使用的物料都是比较干燥的，没有添加水的话是无法正常对物料进行搅拌工作的。因此减水剂以及水在设备操作中的作用还是相当重要的。

Generally, the materials used in the mixer are relatively dry, so it is impossible to mix the materials normally without adding water. Therefore, the role of water reducing agent and water in equipment operation is quite important.

二、确认自上料混凝土搅拌车设备的搅拌罐处于停止的状态

2、 Confirm that the mixing tank from the loading concrete mixer is in the stop state

由于发动机在启动时如果搅拌罐正好处于高速旋转的状态，这时会对设备减速机带来一定的损坏，影响设备的正常使用。

When the engine is started, if the mixing tank is in the state of high-speed rotation, it will damage the reducer of the equipment and affect the normal use of the equipment.

三、对设备的各个零件以及配件进行检查工作，存在问题时可以及时排除

3、 Check the parts and accessories of the equipment, and eliminate the problems in time

1、点火之前先检查机油、防冻液、润滑油和冷却水等，发现不足时，应重新进行添加。

1. Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, and add them again if they are insufficient.

2、车子启动后，再让罐子低速旋转，围绕着车检查轮胎气压，是否有漏气的胎，再用螺丝刀剔掉在胎缝里的石子。

2. After the car starts, let the jar rotate at a low speed. Check the tire pressure around the car to see if there is a flat tire. Then use a screwdriver to remove the stones in the tire seams.

3、再检查灯光，尤其是腰灯，务必保证照着轮胎边缘，工地会经常乱堆放钢筋之类的东西，而胎侧是薄弱的。

3. Check the light again, especially the waist lamp, and make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is the weakest.

4、用抹布擦干净两边的后视镜，窗户玻璃，工地路况复杂，光线不好，视线一定要保证！

4. Clean the rear-view mirror and window glass on both sides with dishcloth. The road conditions on the construction site are complex and the light is not good. The line of sight must be guaranteed first!

一般自上料混凝土搅拌车这种建筑施工设备的操作环境通常都不是很好，这也导致需要我们对设备在操作之前有详细的了解才行。在确保设备不存在有任何故障问题之后才能够操作使用设备正常运行，避免在操作中可能存在的各种不良问题。

Generally, the operating environment of self loading concrete mixer is not very good, which also requires us to have a detailed understanding of the equipment before operation. After ensuring that the equipment does not have any fault problems, it can be operated and used normally, so as to avoid all kinds of bad problems that may exist in the operation.