俗话说，搅拌车三分修七分养，平时保养尤为重要。此次，我们从出车前检修、装卸料过程保养以及运输过程注意事项三部分展开跟大家详细介绍。
As the saying goes, mixer three repair seven, maintenance is particularly important. This time, we will introduce in detail from three parts: maintenance before departure, maintenance during loading and unloading and matters needing attention during transportation.
出车前检查、发现问题并排除故障，搅拌车怕在路上罐子不转，混凝土一般停罐不能超过2个小时，C40以上级别的混凝土在路上罐子就不能停。车子启动后，先让罐子低速旋转，围绕车检查轮胎胎面、胎压等，检查是否有石子、铁钉之类扎在胎里，及时清理干净。
Check and find out the problems and remove the faults before leaving the vehicle. The mixer truck is afraid that the tank will not rotate on the road. Generally, the concrete tank can not be stopped for more than 2 hours, and the concrete tank with the grade of C40 or above cannot be stopped on the road. After the car starts, first let the jar rotate at a low speed, check the tire tread, tire pressure, etc. around the car, and check whether there are stones and nails stuck in the tire, and clean them up in time.
螺栓巡检，包括减速机与罐体连接螺栓、减速机底座固定螺栓、连接件螺栓以及U型螺栓等，在日常运行中一定要做到定期保养，新车出厂前检查是否松动，初次复紧周期为使用前七天，后续每月检查紧固一次，做到防患于未然。
Inspection of bolts includes connecting bolts between reducer and tank body, fixing bolts of reducer base, connecting bolts and U-bolts. Regular maintenance must be done in daily operation. Check whether the new car is loose before delivery. The first tightening cycle is seven days before use, and the subsequent inspection and fastening is conducted once a month to prevent accidents.
 润滑油更换，包括减速机齿轮油、液压系统中的液压油、发动机机油等，一旦缺少就会对相关部件造成磨损，影响车子的整体性能。建议初次工作100小时更换，以后每1000小时更换一次（每年至少更换1次 ）。
Lubricating oil replacement, including gear oil of reducer, hydraulic oil in hydraulic system, engine oil, etc., will cause wear to relevant parts and affect the overall performance of the car. It is recommended to replace it after the first 100 hours of operation, and then every 1000 hours (at least once a year).

  散热器滤芯更换，散热器就等同于车子的呼吸系统，一旦“呼吸”不畅通，就会造成发动机过热从而引发爆缸等问题，所以日常工作中一定要定期检查，更换滤芯，可以和液压系统保养同时更换，真空表指针位于红色区域时更换滤芯，每年至少要更换一次。
When the radiator filter element is replaced, the radiator is equivalent to the breathing system of the car. Once the "breathing" is not smooth, the engine will overheat and cause cylinder explosion. Therefore, it is necessary to regularly check and replace the filter element in daily work, which can be replaced at the same time as the maintenance of the hydraulic system. When the vacuum gauge pointer is in the red area, the filter element should be replaced at least once a year.
 加注黄油，传动轴、滚道、拖轮、主槽转轴、操纵杆等部件要保证每月加注一次黄油，减少关键部件磨损，从而延长使用寿命。
When adding grease, the transmission shaft, raceway, tugboat, main slot shaft, control lever and other parts should be filled with grease once a month to reduce the wear of key parts and prolong the service life.
感谢您的阅读，此文的文章来源：全自动搅拌车更多的内容和问题请点击：http://www.zkzsljbc.com我们会继续努力的为您提供服务，感谢您的支持！
Thank you for reading. This article is from automatic mixer. For more information and questions, please click: http://www.zkzsljbc.com We will continue to work hard to provide services for you, thank you for your support!